Mesquite Pod Harvesting and Storage Tips
Amy Valdés Schwemm and Martha Ames Burgess wrote a short article on safely harvesting and storing mesquite pods, originally published in the Summer 2013 issue of Edible Baja Arizona. Please read and follow their helpful and clear recommendations! The article is also available online on pages 54–55 of the Summer 2013 issue of Edible Baja Arizona. In addition, carefully read and follow our guidelines on avoiding aflatoxin contamination of your harvested pods.
Thanks to those that harvested, analyzed data, and worked with the Mesquite Harvest Working Group in 2012:
Jeau Allen of The Mesquitery (MesquiteFlour.com),
Martha Ames Burgess of FlorDeMayoArts.com,
Nicholas Paul Garber of University of Arizona,
Blake Gentry of Gente de i’itoi A.C,
Brad Lancaster of DesertHarvesters.org and HarvestingRainwater.com,
Gail Loveland of CascabelConservation.org,
Laurie Melrood of Lamidbar Desert Foods (firstname.lastname@example.org),
Meghan Mix and Valerie McCaffrey of BajaAZ.org,
Mark and Lee Moody of ArizonaMesquiteCompany.com, and
Amy Valdés Schwemm of ManoYMetate.com.
Harvest BEFORE the first rain of the summer, or long AFTER the rainy season in the dry conditions of late summer or fall. Rain on mature or nearly mature pods can cause a common soil fungus to grow on mesquite pods and many other crops. However, pods that were collected last year before the monsoons tested safe to eat. Avoiding visible mold DOES NOT ensure safe pods. Dry the pods well before storage, and do NOT wash the pods.
When to harvest
See the upshot above.
Mesquite pods ripen for harvesting throughout the summer. The season in Tucson typically begins in late June and stretches into late September. To avoid toxic mold, the BEST time to harvest is before the summer rains. The harvest can extend into October in cooler areas such as Sahuarita, Sonoita, or Patagonia. Native trees are adapted to our two rainy seasons (winter and summer), and typically go through two flowering phases, one in the spring (April/May) and the other after the monsoon (August). This results in two fruiting phases. Ripe pods may range in color from yellowish tan to reddish (not green), and are dry and brittle. They come off the tree with little pulling.
Where to harvest
Harvesting pods in the city is safe and convenient if you can find an area that hasn’t been cleared of all its vegetation or contaminated by pollutants (see “Where not to harvest” below). We have harvested quality pods from washes, small drainages, city parks, backyards, and along low-traffic neighborhood streets. Often, it is the trees in the city that are the most abundant producers because they are receiving supplemental water or runoff from adjoining hardscape (rooftops, patios, and streets).
Where NOT to harvest
Do not harvest from areas that are polluted or contaminated. These include:
– Highway corridors and other areas with high volumes of vehicular traffic and air-borne pollutants,
– Areas where there is known or suspected use of sprayed pesticides or herbicides,
– The ground, as there is likely to be animal waste or contaminated street runoff coming into direct contact with the pods.
If you are unsure about harvesting in a certain area, just err on the side of caution and avoid it. Start observing mesquite trees in the landscape more closely and you will figure it out in no time!
How to harvest
Ripe pods are best picked from the tree rather than gathered off the ground, since they will be cleaner and there is far less chance that there will be any mold, dirt, or fecal matter on the pods. Ripe pods only require the slightest pull to remove them from the tree. If you need to pull hard, the pods are not ripe. Avoid pods with black mold spots on them.
Taste before you pick
Once you have found a tree that you want to pick from go ahead and TASTE one of the pods (watch out for the very hard seeds). If it tastes good to you, go ahead and pick from that tree. The flavor can vary widely from one tree to the next. If you are unfamiliar with the taste of good mesquite, it is a good idea to sample pods from several different trees.
Note: Preferred flavors vary depending on who is doing the tasting, though Desert Harvester Anastasia has found that non-native Chilean mesquite pods often have a chalky taste to them that is reminiscent of Pepto-Bismol. Native velvet, screwbean, and honey mesquites tend to have a sweet, nutty flavor. The four undesirable characteristics you want to avoid in any pod are: bitter, chalky, or causing a burning sensation in back of the throat, or drying of the mouth.
Keep in mind that no matter how you cook or process your mesquite pods, if you start with any undesirable characteristic in your pods, this will carry through into your end product. Whereas, good-to-great-tasting pods will allow for good-to-great-tasting results!
We usually carry a few bags with us wherever we go during mesquite season so that we can pick if we happen to find a good tree. Don’t forget about the wildlife—leave some pods for them, too (though there are usually ample pods on the ground for critters).
Drying your pods
If you’ve picked your pods when they are dry enough to readily snap in two when bent, you are likely all set. But to ensure your pods are perfectly dry, it’s wise to lay your pods out on drying racks, a clean metal surface, or even a clean cloth spread over the ground during the day. At night, you must bring your pods inside to prevent evening and early-morning moisture from being absorbed by your pods. When the pods readily snap in two when bent, they are ready for storage.
Another option for drying your pods is to dry/roast them in a solar oven, conventional oven, or over a fire.
Storing mesquite pods
Store completely dry pods in airtight, food-grade containers in a dry, temperature-stable, rodent-free location until milling day. Caution: Plastic garbage cans often contain a biocide in the plastic, which can leach into your pods.
Bruchid beetles will likely hatch out of the pods during storage (they are what make the small holes in the pods), but this is not something to be alarmed by since they are harmless. For those that are set on reducing the potential of bruchid beetles hatching out during storage, you can put pods in a solar oven (or a low-heat conventional oven) for a few hours, then take the pods out and make sure they are thoroughly dry. Once thoroughly dry, put the pods in a sealed, airtight container.
Please be sure the pods you bring for milling are clean and free of gravel, dirt, or any other debris that could damage the mill or contaminate the flour. Only clean, dry pods will be ground. All pods must pass inspection prior to being milled.
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
Excerpted from The Tumbleweed Gourmet by Carolyn J. Niethammer
click here for ordering info
Because mesquite pods have the shape and size of a green bean they are often called mesquite “beans,” which has caused some misunderstanding of how the fruit is used.
Not all of the mesquite pod is edible — a great deal of it is indigestible fiber. The most accessible edible portion of the pod is the pulp or pith between the brittle outside and the hard seeds. Ordinary bean pods do not have this pith. This portion has a very sweet, brown-sugary flavor and can be ground into a meal for use in baking . The pith surrounds a number of stone-hard seeds, inside of which are found the protein-rich embryos or true seeds.
It is almost impossible to crack the hard seed coats with home methods; however, in the past, Indians who lived in the desolate Pinacate Mountains on the Mexican-American border devised a stone implement, given the name “gyratory crusher” by its discoverer, archaeologist Julian Haydn. It looks like a grinding stone with a hole through it and for years investigators thought the artifacts they found were just worn-out grinding stones, or metates. But Hayden surmised the hole had a purpose. As it turns out, when a heavy wooden pestle is manipulated in these stones, the mesquite seeds can be cracked, an ingenious bit of technology invented by protein-hungry people.
A modern-day equivalent of the gyratory crusher is a fairly common piece of farm and milling equipment called a hammermill. A hammermill can crush and grind both the pith and the seeds of mesquite pods and sift out most of the debris automatically. People who can beg or talk their way into the use of one of these machines can provide themselves with great quantities of high-protein mesquite meal with little effort.
Desert Harvesters owns a community hammermill and holds annual community millings. Click here to see our hammermill page.